A beautiful kitchen, a bright living room and a neat bathroom quickly make a good impression. Yet these parts do not tell the whole story. The biggest costs are often in places that stand out less during a viewing: under the floor, behind the walls or up on the roof.
You do not need to be a building surveyor to ask targeted questions. By looking beyond the finish, you get a better picture of the condition of the home and the costs you may be able to expect.
1. Damp: look for the cause
Damp problems are not always immediately visible. So do not look only for obvious leaks, but also for smaller signs:
- Brown or yellow rings on ceilings
- Peeling wallpaper or flaking paint
- Mould near windows, in corners or behind furniture
- A musty smell, especially on the ground floor
- Damp patches at the bottom of walls
A damp patch can have various causes, such as a leaking roof, a problem with the pipes or insufficient ventilation. The solution differs per cause.
So ask: when did the patch appear, what was the cause and how was it remedied? For earlier repairs, also ask for invoices or reports. Simply repainting does not remedy the cause.
2. The roof: big costs above your head
During a viewing you often see only part of a roof. Yet overdue maintenance here can lead to considerable costs.
From a safe spot, look at whether roof tiles are missing, gutters are damaged or there are traces of damp in the attic. Also pay attention to the joints around chimneys, roof windows and dormers.
Ask when the roof was last maintained and which parts have been renewed. New roof covering does not automatically mean that the roof structure and insulation have been dealt with as well.
If in doubt, an inspection by an expert is sensible. Not every roof can be fully assessed during an ordinary viewing or structural survey (bouwkundige keuring).
3. Cracks, sloping floors and foundations
Not every crack means that there is a serious problem. Small cracks in plasterwork, for example, can arise from the natural movement of materials. Other signs can be a reason for further investigation.
Look out in particular for combinations of:
- Cracks in outer walls or interior walls
- Floors that clearly slope
- Windows or doors that stick
- Visible leaning or subsidence
Ask whether anything is known about the foundations and whether any investigation or repair has taken place before.
A viewing gives no certainty about the condition of the foundations. An ordinary structural survey, too, can at most provide indications. If foundation problems are suspected, a separate foundation investigation may be needed.
4. Window frames, glazing and outer walls
Window frames and outer walls not only determine how the home looks, they also protect it against wind and weather.
With wooden frames, look for damaged paint, open joints and visible decay. Also check whether windows and doors close properly. Condensation or a haze between the panes can point to a failed seal in the insulating glass.
Outside, also look at the brickwork and the pointing. Loose pointing, cracks and damage deserve attention.
Ask what maintenance has been carried out recently. A coat of paint can make the home look neat, but in itself says little about the condition of the wood underneath.
5. Floors and crawl space
A beautiful floor finish can hide the state of the floor underneath. While walking around, pay attention to noticeable springiness, differences in height or a musty smell.
Ask whether the home has a wooden or a concrete floor and whether any problems are known, such as wood rot, damp or deterioration of the concrete.
Is there a crawl space (kruipruimte)? Then ask whether it is accessible and whether it has been investigated before. Do not go into an unfamiliar crawl space yourself; have an expert assess what can be examined safely.
Even during a structural survey, a crawl space is not always inspected in full. So check in the report which parts were actually inspected.
6. Heating, electrics and pipework
Installations stand out less than a new kitchen, but replacing or adapting them can cost a lot.
Ask about the age, the maintenance and the ownership of the central heating boiler, heat pump or other heating system. Is a system rented or leased? Then ask about the contract and the obligations that come with it.
Also look at the meter cupboard (meterkast). Have circuits been added later for, for example, an induction hob, solar panels or a charging point? Ask who carried out this work.
With visible pipework, look for leaks and traces of rust. A tidy meter cupboard or a working tap does not give full certainty about the installation. If in doubt, a specialist check may be needed.
7. Insulation and ventilation
A home can be neatly finished and still use a lot of energy. So look at the energy label, but also ask which measures have actually been carried out.
Think of roof, floor and wall insulation and the type of glazing. Where possible, ask for invoices or other supporting documents.
Also pay attention to ventilation grilles and extraction in the bathroom, toilet and kitchen. Good insulation and sufficient ventilation have to match each other.
If you wish, ask about the energy consumption of the current occupants. That gives background information, but does not predict your own consumption exactly: household size, heating habits and the use of rooms make a big difference.
8. Renovations and older materials
Has the home been extended or has the layout been changed? Then ask what work was carried out and whether the necessary drawings, calculations and any permits are available.
Especially where walls have been removed, it is important to know whether the load-bearing structure has been properly adapted. A sleek finish does not prove that the work was carried out correctly in technical terms.
In homes from before 1994, asbestos may also be present, for example in old panels, floor covering or pipe insulation. It cannot always be recognised with the naked eye. If you want to renovate, an investigation may be needed before the work starts.
9. An apartment? Look at the VvE as well
With an apartment you look at more than your own home. Maintenance of, for example, the roof, the outer walls and shared installations is often arranged jointly through the homeowners’ association (Vereniging van Eigenaars, VvE).
Ask about the maintenance plan, the financial reserve, recent minutes of meetings and planned work. Have any extra contributions been announced?
A low monthly contribution is not automatically a good deal. If not enough money has been saved, owners may later have to pay in a large amount.
10. Have doubts investigated before you decide
A viewing helps you to recognise points that need attention. A structural survey gives more insight into visible defects and expected maintenance costs, but is no guarantee that every hidden problem will be discovered.
With a report, always ask:
- What was actually examined?
- Which parts could not be reached?
- Which costs are needed straight away and which are expected later?
- Has additional specialist investigation been advised?
Weigh up important uncertainties and possible costs before you take a final decision. Also discuss in good time which conditions you want to include in a bid.
During viewings we always look at these points together with you. We ask targeted questions and discuss what possible defects or maintenance work could mean for you. Is there reason for a structural survey or specialist investigation? Then we point that out to you, so that you can make a well-informed choice.
